Vox Infragilis
The ‘control center’ for a ‘birds-eye view’ monitoring, and seamless control of the Wisycom’s entire Distributed Antenna System.
The most powerful line of receive antennas, boosters, and filters.
LBN2
Directional Antenna
LBN2 is a wideband UHF LPDA antenna (log periodic dipole array).
Features:
• Skeletal Design LPDA for Minimal Wind Loading
• Future proof huge reception bandwidth 420-1300 GHz
• Bend elements for maximum directionality with minimum size
• 6 dBi gain
• Typical beam width of 140-degrees
• Robust metal support with fine slope tuning
• Full metal support and mounting base (1/4″ & 3/8″)
• Textured Weather-Resistant Coating
• Waterproof with gasket sealing
• BNC connector (LBN2) or N connector (LNN2) available
ADB2
Omnidirectional Antenna
ADB2 is a wideband, UHF omnidirectional antenna.
Features:
• Huge frequency range of 400-1160 MHz
• 3.2 dBi of gain
• Stationary wave ratio < 1:1.5 in the range 450÷870 MHz and < 1:1.9 in the range 400÷937 MHz
• OIP3: +43 dBm (Output 3° order Intercept Point) typical
• Epoxy fiberglass (copper – clad) with black matte finish
• 5/8” mounting or 3/8” with adapter
• BNC connector (ADB2) or N connector (ADN2) available
BAA
Wideband Antenna Amplifier
BAA is a wideband antenna booster designed to increase gain up to 16 dB in applications with long cables feeding wireless microphone receivers.
Features
• Wide bandwidth operation 470-870 MHz
• Very high linearity (OIP3 > 40 dBm) to prevent distortion
• Up to 16 dB gain adjustable in 1 dB steps
• Powered via coax
• Pass thru DC available for device cascade operation of several BAAs
BAW
High Power Wideband Antenna Amplifier
BAW is a high-power wideband antenna booster designed to increase gain up to 22 dB in applications with long cables feeding wireless microphone receivers.
Features:
• Wide bandwidth operation 470-870 MHz
• Very high linearity (OIP3 > 47 dBm) to prevent distortion
• Up to 22 dB gain settable in one dB step
• Powered via coax
• Pass thru DC available for device cascading
• RGB LEDs for status indications
BFA
Wideband Antenna Amplifier
with remoted controlled filters
BFA integrates a powerful bank of filters along with a low noise amplifier for maximum reception control. Adjust via navigation buttons and a TFT display or remotely via coax using the Wisycom Manager Network.
Features
• Huge reception band: 410-1300 MHz
• Remote controllable via Wisycom Manager Network
• RF gain from -12 to +27 dBu (1 dB steps)
• Easy configuration via onboard buttons and TFT display
• Adjustable bandpass filter for precise interference control
• Antenna off for RF zone disabling
• Fixed band saw filter (940-960 in USA)
• Pass thru DC available for device cascading
• 3 High Pass & 3 Low Pass filters
• Waterproof with gasket sealing
LFA
Directional Antenna with Remote
Controllable Amplifier and Filters
The LFA combines the accurate, rugged, wind-resistant design of the LBN2 directional antenna with the power of the BFA active amplifier with remote-controllable filters for maximum reception control. Designed to withstand the elements, the LFA gives a full antenna control of multiple RF zones via the Wisycom Manager Network.
Features:
• Huge reception band: 410-1300 MHz
• Remote controllable via Wisycom Manager Network
• RF gain from -12 to +27 dBu (1 dB steps)
• Easy configuration via onboard buttons and TFT display
• Adjustable bandpass filter for precise interference control
• Antenna off for RF zone disabling
• Fixed band saw filter (940-960 in USA)
• Skeletal design for low wind loading
• 3 High Pass & 3 Low Pass filters
• Waterproof with gasket sealing
ADFA
Omni Antenna with Remote Controllable
Amplifier and Filters
The ADFA combines the rugged, weather-resistant design and linear characteristics of the ADB2 with the power of the BFA active amplifier with remote-controllable filters for maximum reception control. The ADFA gives a full antenna control of multiple RF zones via the Wisycom Manager Network.
Features:
• Huge reception band: 410-1160 MHz
• Remote controllable via Wisycom Manager Network
• RF gain from -12 to +27 dBu (1 dB steps)
• Easy configuration via onboard buttons and TFT display
• Adjustable bandpass filter for precise interference control
• Antenna off for RF zone disabling
• Fixed band saw filter (940-960 in USA)
• Skeletal design for low wind loading
• 3 High Pass & 3 Low Pass filters
• Waterproof with gasket sealing
LBNA2
Directional Antenna with Amplifier
The LBNA2 combines the accurate, rugged, wind-resistant design of the LBN2 directional antenna with the 16 dB of adjustable gain offered by the BAA is a wideband antenna booster.
Features:
• Skeletal Design LPDA for Minimal Wind Loading
• Typical beamwidth of 140-degrees
• Wide bandwidth operation 470-870 MHz
• Very high linearity (OIP3 > 40 dBm) to prevent distortion
• Up to 16 dB gain adjustable in 1 dB steps
• Powered via coax
RECEIVE COMBINERS
Unmatched cost-efficiency and flexibility for multi-zone RF
Wisycom’s RF Combiners offer unmatched cost-efficiency and flexibility to multi-zone system design by utilizing antenna network rather than duplicating wireless receiver per zone. Furthermore, they simplify and minimize complementary equipment and interconnects such as signal processors, console inputs and required cabling.
MAT288
Diversity RF Matrix Combiner
The MAT288 is a programmable RF Matrix Combiner designed for applications in which multiple zones of diversity antennas are routed to feed wireless audio receivers.
Configurations:
• 8:1 Diversity Combiner with 6dB gain
• 8:4 Diversity Combiner with 0dB gain
• 2x 4:2 Diversity Combiners
MAT244
RF Matrix Combiner
The MAT244 is a programmable RF Matrix Combiner designed for applications in which multiple zones of diversity antennas are routed to feed wireless audio receivers.
Configurations:
• 4:2 diversity combiner with 7dB gain
• 8:4 non-Diversity combiner
• 8:1 non-Diversity combiner with 7dB gain
Compact Combiner / Splitters
Wisycom's series of compact, passive wideband combiner / splitters are great problem solvers.
Each possesses unique features to fit specific needs.
CSA121A
CSA121A Wideband Combiner / Splitter
• Passive Combiner →1 x 2:1
• Passive Splitter →1 x 1:2
• DC-coupled for use with antenna booster/ active antennas.
• Handles up to 1.5 Amps for high power IP3 booster driving (i.e. Wisycom BAW)
• Supplied with 230/110 Vac power supply with locking connector
CSA121B
CSA121B Wideband Combiner / Splitter
• Passive Combiner →1 x 2:1
• Passive Splitter →1 x 1:2
• Works with input power up to 2W
• DC pass-through for antenna booster powering
CSA221
CSA221 Wideband Combiner / Splitter
• Passive Combiner →2 x 2:1
• Passive Splitter →2 x 1:2
• DC pass-through for antenna booster powering
• Handles up to 1.5 Amps per side for high power IP3 booster driving (i.e. Wisycom BAW)
Providing the most control and cleanest signal path for each antenna's RF
Wisycom SPL2216 and SPL2208 offer maximum splitting that adds combining flexibility in a 1RU chassis for wireless mic receiver applications. Designed to maintain RF integrity, these splitters possess quality components and circuit design for the highest RF robustness and linearity to resist intermodulation distortion with applications utilizing high-density equally spaced frequencies.
SPL2216
Active Combiner / Splitter
2 diversity zones x 16 diversity outputs
SPL2208
Active Combiner / Splitter
2 diversity zones x 8 diversity outputs
The ability to split one or two pairs of diversity pair antennas adds flexibility shared by no other splitters on the market today. This provides unparalleled features to the SPL2208, while the SPL2216 adds the ability to feed twice as many wireless microphone receivers than any other multi-coupler available.
SPL2216 & SPL2208 Features:
• Wideband operation: 170-1260MHz
• Perfect for 1 or 2 zone applications
• Split outputs for 2) MAT288 units
• Cascade to additional SPL for additional diversity outputs
• Remote control via Wisycom Manager Network
TRANSMIT COMBINERS
Passive combiners that eliminate combiner loss for use with the MTK952 Transmitter (2WO version).
Transmit Combiners
Passive combiners designed to deliver power compensation benefits when used with the MTK952 Transmitter (2WO version).
CSI16T
Smart Transmit Combiner
(For use with the MTK952 IEM/IFB 2WO Transmitter)
The CSI16T is a passive, wideband combiner specifically designed for use with the MTK952 IEM/IFB Transmitter (2WO version with up to 2 watts output). The CSI16 communicates with the MTK952 Transmitter to compensate for combiner loss by increasing power from the TX side!
Other features:
CSA121T
Smart Transmit Combiner / Splitter
• Passive Combiner →1 x 2:1
• Passive Splitter →1 x 1:2
• Works with high input power – up to 3W
• Becomes a smart combiner when used with Wisycom MTK952 Transmitter
• Recovers combiner loss as MTK952N increases output power as needed
Note: the CSA121T does not have 12V Bias pass-through capabilities
The right tools for optimal transmission radiation and gain
PAW
Wideband Antenna Amplifier
PAW is a wideband antenna amplifier for RF over fiber or other applications requiring increased gain to transmit antennas.
Features:
• Amplifies RF signal 20 dB (Max 250 mW EIRP)
• Powered by 12V bias via coax from transmitter or MFL system
• Rugged aluminum waterproof chassis
• PAWN version features waterproof sealed N connector
Variations:
• PAW-V working in 170-250 MHz
• PAW-L working in 435-700 MHz
• PAW-H working in 566-800 MHz
LBP-LNP
Wideband Antenna with Amplifier
The LBP/LNP combines the accurate, rugged, wind-resistant design of the LBN2 directional antenna with an integrated PAW wideband antenna amplifier for RF over fiber or other applications requiring increased gain to transmit antennas.
Features:
• Amplifies RF signal 20 dB (Max 250 mW EIRP)
• LPDA design enhances transmission ~ 6dB gain
• Powered by 12V bias via coax from transmitter or MFL system
• Rugged aluminum waterproof chassis
• LNP version features waterproof sealed N connector
Variations:
• LxP -L working in 435-700 MHz
• LxP -H working in 566-800 MHz
• LxP -X working in up 960 MHz
• LxP -W working in up 1300 MHz
MPA4
4 X 4 Power Amplifier
MPA4 is a quadruple wideband antenna amplifier for RF over fiber or other applications requiring increased gain to transmit antennas.
Features:
• Wideband operation range/ model of 470-620 MHz/ 600-800MHz
• Highly linear for reamplification of multiple carriers without intermod: OIP3 > 50dBm
• Powered by 110/230 Vac
• Optional redundant 12VDC power supply available
LBN2
Directional Antenna
LBN2 is a wideband UHF LPDA antenna (log periodic dipole array).
ADB2
Omnidirectional Antenna
ADB2 is a wideband, UHF omnidirectional antenna.
Wisycom’s RF over fiber system is based on the MFL framework - a modular, flexible design that maintains RF integrity with dynamic range control, networking ability, and backup redundancy that satisfies the needs of any production.
MFL
Wideband Optical Link
Wisycom Manager integrates Combiners, Splitters, remote RF Fiber Links for complete monitoring and control of the entire Wisycom Distributed Antenna System. Simply stated, this smart network is controlled by:
Real-time remote monitoring and control of Distributed Antenna Systems include: