RPU500

Fixes:
• Tinny Audio on RX with ENS expander (ENS-NB, ENS-50K, ENS-12K5)
• Wrong CTCSS tone detection with COM12K5 expander

Fixes:

• RX: Audio mute changing the compander/HP_MIX.

Changes:

• RX: Added RX Mode “COM-12K5” for compatibility with other brand of Communication TX.
• RX: Added CTCSS for RX Mode “COM-12K5”.
• RX: HP_MIX Factory value to RX for Full Duplex.
• TX: Reduced TX latency.
• TX: Added LPF type STD (standard) and L.L. (Low Latency).
• TX: Added min. freq. settable when RX ON.
• TX: Removed Batt. Data “N” (Normal) 8 bit.

KNOW ISSUE: tinny audio on RX with ENS expander

• added 8 customize power levels
• added headphone listening of received + incoming MIC signal (new Audio menu: HP mix and HP Balance)
• improved frequency change when TX off (full duplex version)
• fixed bug: RX switches on at freq 000.000 when TX in wrong freq. range

• fixed minor audio bug
• fixed minor graphic bug

• VHF band enabled for RPU500 full duplex

• add compatibility with Full duplex version

• RF Power targeting algorithm optimize.
• Antenna SWR readout and warning signalling optimized.

• Added PTT function on Lazy buttons.
• Added “Info > STD (Standard)” menu.

• Added new “Talk+Lazy” mode on “TX start” menu which allows lazy buttons handling while Talk button is locked.
• Changed “REV” to “RFL” in TX RF diagnostic status page.
• Frequency plan and power profile compatibility updated.
• Battery graphic icon updated.
• Bug fix: when TX start mode set on “Talk” in some cases after the power on the transmitter does not activate the connection.

• Changed: Remaining battery time is displayed in hours and minutes.
• Added: the possibility to switch on the device in continuous transmission. A lock icon appears on the display to inform the user that Talk and Lazy buttons are locked.

• Improved battery communication
• Added page to enable IRDA communication and Sync function
• Added data battery extended (16 bits transmission mode)