MTP60

New:

• Added new battery profile “LBPXL”
• reduced battery charge’s status calculation time at startup

Bug fix:

• Improved Lithium battery profile (Energizer and Varta)
• Wrong Jam with Tentacle Track-E at 23.98 or 29.97

New:

• Added new battery profile “Lithium Varta”.

Bug Fix:

• Incorrect battery detection after replacement with another model.

New:

• Added FLAT compander for audio measurement (enabling Settings>Compander extended).
• Added reset recording parameters during SD format.

Bug Fix:

• Fault TC sync with 29.97 e 59.94 DF/RT.
• Improved battery algorithm.

Changed

• Battery algorithm improved
• Display OFF using EXIT button in main page added
• BT timecode Jam with Tentacle devices adde

Bug FIX

• Display OFF shutdown LED too
• REC module updated
• BT module updated

Use Wisycom Manager 3.4.2. 

• added management of JP version
• added JP and KR certificates
• added management of frequency steps other than 5KHz
• added Ladda battery profile
• changed display switch ON procedure (to reduce power consumption bug)
• minor recording bug

Bug FIX:

• RF does not activate during power up if the SEL/ON button is held down for too short a time.
• Fixed SN used in BT advertising packets.
• Sporadic recording issue with some types of SD card.

Changed:

• manual setting of the FPS
• FPS 30.00DF added.
• TC invalidation: TC blinking when JAM invalidated (TC is valid for 2 hrs after shutdown WITHOUT batteries)
• SD operations history log file in CSV format.
• BT operations speed improved.
• Freq-Gr-Ch edit page behaviour improved.

Bug FIX:

• TC Setup page menu revised.
• Graphic changes in TC Setup menu.
• At power ON, if RTC (Real Time Clock) date is not valid, Jan-01-2022 is set.
• Fixed FPS not being correctly save from BT app.
• Fixed device battery 0% level detection on Rx before the valid level is calculated.
• Fixed issue on TC showing 00:00:00 after power-down.
• Peak Hold time adjusted.
• Minor bug fix.
• Minor graphic fix.

BOOTLOADER MTP60_BL_v1.2.0
• Bootloader upgrade to v1.2
• Bug fix: Timecode slipping after reboot

FIRMWARE MTP60_v1.6.0
New
• Add SD format (exFAT).
• Add SD icon when SD card detected.
• Add compatibility with Wisycom BT App.
• Add recorded file recovery when recording is stopped accidentaly.
• Add automatic audio gain setting during JAM.
• Changed 32-bit recording source signal.
• Improved the audio gain structure on the input stage.
• Changed Mic Mode menu (2W&P to PHA60-12, 2W+B&P to PHA60-48).
• Removed NiMh battery status pop up.
Bug FIX:
• Fixed TC in advance with Not Dropped Frame Rate
• Fixed TC slipping after reboot.
• Fixed the loss of Bit Depth setting after a reboot.
• Fixed bug on battery life detection.
• Minor bug fix

Below the video with the instruction to upgrade the Bootloader to v1.2.0 and firmware to v1.6.0:

New:

• New algorithms for battery time estimation
• Added recording function
• Improved some graphic details

Bug fix:

• Minor bug fixed

NOTE: For a full audio compatibility  we recommend to upgrade your MCR54/MCR54-DUAL  to the latest firmware version
MCR54 firmware v1.22.0
MCR54-DUAL firmware v1.22.0